AT&T CL82143 - Handset Operation; Making, Answering, and Ending Calls

Telephone operation
18
Options while on calls
Chain dialing
Use this feature to initiate a dialing sequence from the numbers in the directory,
caller ID history or redial memory while you are on a call.
To access the directory or caller ID log while on a call:
Press MENU/SELECT.
Press qCID or pDIR to scroll to >Directory or >Caller ID log, then press
MENU/SELECT.
Press qCID or pDIR to scroll to the desired number.
Press MENU/SELECT to dial the number shown.
To access the redial list while on a call:
Press REDIAL/PAUSE to show the most recently dialed number.
Press qCID or pDIR to scroll to the desired number, or press REDIAL/PAUSE
repeatedly to show the last 10 recently dialed numbers. Press MENU/SELECT to
dial the number shown.
Blind transfer
While on an outside call, you can transfer it to a specific handset or any
handset.
To transfer an outside call directly without notifying the desired handset:
1. During the call, press MENU/SELECT.
2. Press MENU/SELECT to choose >Transfer.
If you have a two-handset system, the outside call is put on hold and your
handset screen shows Transferring call... The other handset rings and its
screen shows Transfer from other handset.
If you have more than two handsets, your screen shows TRANSFER TO:
Press qCID or pDIR to scroll to the desired handset and press
MENU/SELECT. The outside call is put on hold and your handset screen
shows Transferring call... or Transferring call to all...
3. To answer the call on the destination handset, press PHONE/FLASH,
/SPEAKER, or any dialing key (0-9, TONE , or #). The original handset
shows Call transferred and goes to idle mode.
1.
2.
3.
4.
1.
2.
•
•