AT&T CL82450 - Use Caller ID to Automatically Set Date and Time

13
Handset settings
6. Press qCID or pDIR to select the day then press
MENU/SELECT, or enter the number using the dial pad keys.
7. Press qCID or pDIR to select the year then press
MENU/SELECT, or enter the number using the dial pad keys,
then press MENU/SELECT to confirm.
8. Press qCID or pDIR to select the hour then press
MENU/SELECT, or enter the number using the dial pad keys.
9. Press qCID or pDIR to select the minute then press
MENU/SELECT, or enter the number using the dial pad keys.
10. Press qCID or pDIR to highlight AM or PM, then press MENU/SELECT to
confirm. There is a confirmation tone. Press OFF/CLEAR to cancel.
NOTE: If the clock is not set when a message is recorded, the system announces, “Time and
day not set,” before it plays the message.
Use caller ID to automatically set date and time
Follow the steps below to turn the CID time sync feature on or off. The
default setting is On.
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to >Settings, then press
MENU/SELECT.
3. Press qCID or pDIR to scroll to >Set date/time, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to >CID time sync, then
press MENU/SELECT.
5. Press qCID or pDIR to highlight On or Off, then press
MENU/SELECT to confirm. There is a confirmation tone.
SET DATE
--/--/--
SET TIME
--:-- --
CID TIME SYNC
> On
> Date & time
CID time sync
> Settings
Website
Telephone settings