19
Toll saver - the answering system answers a call after two rings if
you have new messages, and after four rings when there are no new
messages. This feature allows you to check for new messages and avoid
paying long distance charges when calling from out of your local area.
6. Press MENU/SELECT to confirm your setting. You hear a confirmation tone.
Press OFF/CLEAR to cancel.
NOTE: If you subscribe to voicemail service through your telephone service provider, see
Answering system and voicemail on page 40.
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). Unless you change it, the remote
access code is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to >Ans sys setup, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to >Remote code, then
press MENU/SELECT.
5. Use the dial pad to enter a two-digit number. Use
MUTE/DELETE to backspace and delete a digit.
6. Press MENU/SELECT to confirm your setting. You hear a
confirmation tone. Press OFF/CLEAR to cancel.
•
Answering system settings
Telephone settings
>
Remote code
Msg alert tone
>
Ans sys setup
-End of list-
Play messages
>
Answering sys
REMOTE CODE
19
To Next Page
Loading...
