56
Troubleshooting
My cordless handset isn’t performing normally.
Make sure you plug the power cord securely into the telephone base. Plug the 
power adapter into a different, working electrical outlet without a wall switch.
Move the cordless handset closer to the telephone base. You might have 
moved out of range.
Reset the telephone base. Unplug the electrical power. Wait for 15 
seconds then plug it back in. Allow up to one minute for the cordless 
handset and telephone base to reset.
Other electronic products can cause interference to your cordless phone. 
Try installing your phone as far away from these types of electronic 
devices as possible: television sets, VCRs, or other cordless telephones.
Out of range OR No pwr at base appears on my cordless handset.
Ensure you plug the telephone base in properly and the power is on.
Place the cordless handset in the telephone base for one minute to allow 
the cordless handset and base to synchronize.
Move the cordless handset closer to the telephone base. You might have 
moved out of range.
Reset the telephone base. Unplug the electrical power. Wait for 15 
seconds then plug it back in. Allow up to one minute for the cordless 
handset and telephone base to reset.
Other electronic products can cause interference with your cordless 
phone. Try installing your phone as far away from these types of electronic 
devices as possible: television sets, VCRs, or other cordless telephones.
The batteries do not hold a charge.
If the cordless handset is in the telephone base or charger and the charge 
light is not on, refer to The charge light is off or blinking (page 59).
Charge the battery in the cordless handset for at least 16 hours. For 
optimum daily performance, return the cordless handset to the telephone 
base or charger when not in use.
If the battery is depleted, it might take approximately 30 minutes to 
charge the handset before it shows Low battery. Refer to the table on 
page 6 for details.
You might need to purchase a new battery. Please refer to Battery 
installation and charging in this user’s manual on pages 6-7.
•
•
•
•
•
•
•
•
•
•
•
•
•
Appendix