Multiple handset use
50
Push-to-talk (PTT)
Make an outgoing call during PTT call
During a one-to-one PTT call, press PHONE/FLASH on your handset or
/SPEAKER on your telephone base to get a dial tone. The PTT call
ends automatically.
During a PTT call, press PHONE/FLASH on the initiating handset
or /SPEAKER on the initiating telephone base. The PTT call ends
automatically and you get a dial tone.
During a PTT call, press PHONE/FLASH on any one of the destination
handsets or press /SPEAKER on the destination telephone base. That
device gets a dial tone. The PTT call continues for the rest of the PTT
participants.
End or leave a PTT call
For one-to-one PTT calls, both initiating and destination devices can end the
PTT call. For PTT calls to multiple devices, the initiating device can end the
PTT call. If any one of the destination devices leaves the PTT call, the call
continues until all participants or the initiator hangs up.
Press OFF/CANCEL on the handset or place the handset in the telephone
base or charger, or press CANCEL on the telephone base. The screen shows
Push to talk Ended.
NOTE: After PUSH TO TALK on the handset or PTT on the telephone base is released, the
PTT call remains open for a short time. If no one presses PUSH TO TALK on the handset or
PTT on the telephone base within ten seconds, the PTT call ends automatically.
•
•
•
To Next Page
Loading...
Need help?
General
