AT&T CL83201 Complete User's Manual

88
Adding and registering handsets/headsets
Your telephone can support up to 12 DECT 6.0 cordless handsets (AT&T model
CL80111, sold separately) or up to ten cordless handsets and two cordless
headsets (sold separately). Visit www.telephones.att.com/headsets
for a list of compatible DECT 6.0 cordless headsets. Each new handset or
headset must be registered to the telephone base before use. You must
register each handset or headset separately.
To register a cordless headset to this telephone system, please refer to the
user’s manual of the cordless headset for more details. To register a cordless
handset, see below.
The handsets provided within your product box are already registered as
HANDSET 1 and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HANDSET 12).
Register a handset to the telephone base
1. Before you begin registration, make sure the handset is out of the telephone
base or charger and shows To register, see manual.
2. Put the handset you wish to register on the telephone
base cradle.
3. Both the handset and the telephone base show
Registering... Please wait and the IN USE light on the
telephone base turns on. Then HANDSET X Registered
appears on both the handset and the telephone base
screens ((HANDSET represents the handset name,
X represents the handset number). Both the handset and
the telephone base beep and the IN USE light turns off.
The handset is now registered with the telephone base.
If registration fails, the system will automatically try
to register again. If registration fails after the third try,
Registration failed appears on both screens. Then the
handset shows To register, see manual and the telephone
base returns to idle mode. This
may take up to five minutes to
occur. Please start again from
Step 1 above.
NOTES:
You cannot register a handset if
any other system handset is in use.
If you try to register more than
12 handsets to the telephone
base, the telephone base shows
Registration slots are full and
sounds two beeps.
•
•
To register,
see manual.
Registering...
Please wait
HANDSET X
Registered
Appendix
For registration, put the handset on the telephone
base, not the handset charger.

AT&T CL83201 Specifications

General

Brand	AT&T
Model	CL83201
Category	Cordless Telephone
Language	English