AT&T CL83201 - Appendix; Adding and Registering Handsets; Register a Handset to the Telephone Base

88
Adding and registering handsets
Your telephone can support up to 12 cordless handsets. A new handset
(AT&T model CL80111, purchased separately) must be registered to the
telephone base before use. You must register each handset separately.
The handsets provided within your product box are already registered as
HANDSET 1 and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HANDSET 12).
Register a handset to the telephone base
1. Make sure the handset is out of the telephone base or
charger and shows Put HS on BASE to register before you
begin registration.
2. Put the handset you wish to register on the telephone
base cradle.
3. Both the handset and the telephone base show
Registering... Please wait and the IN USE light on the
telephone base turns on. Then HANDSET X Registered
appears on both the handset and the telephone base
screens ((HANDSET represents the handset name,
X represents the handset number). Both the handset and
the telephone base beep and the IN USE light turns off.
The handset is now registered with the telephone base.
If registration fails, the system will automatically try
to register again. If registration fails after the third try,
Registration failed appears on both screens. Then the
handset shows Put HS on BASE to register and the
telephone base returns to idle mode. This may take up
to 5 minutes to occur. Please start again from
Step 1 above.
NOTES:
You cannot register a handset if any other system handset is in use.
If you try to register more than 12 handsets to the telephone base,
the telephone base shows Registration slots are full and
sounds 2 beeps.
•
•
Put HS on BASE
to register
Registering...
Please wait
HANDSET X
Registered
Appendix
For registration, put the
handset on the telephone
base, not the handset charger.