AT&T DLP73290 - Message playback

150
Answering system
Answering system settings
Number of rings
You can set the answering system to answer an incoming call aer two, three,
four, ve, or six rings. You can also select toll saver, which is explained below. By
default, the answering system answers an incoming call aer four rings.
To set the number of rings:
Using a cordless handset:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press
MENU/SELECT.
3. Press CID or DIR to highlight Ans sys setup, then press
MENU/SELECT.
4. Press CID or DIR to highlight # of rings, then press
MENU/SELECT.
5. Press CID or DIR to choose from 6, 5, 4, 3, 2 or Toll saver.
f Toll saver - the answering system answers a call aer two rings when you
have new messages, or aer four rings when there is no new message.
This feature allows you to check for new messages and avoid paying long
distance charges when calling from out of your local area.
6. Press MENU/SELECT to save.
Using the telephone base:
1. Press Menu sokey, and choose Answering system .
2. Press / / / to scroll to the next page, and then select
Number of rings .
3. Press your desired number of rings.
ANSWERING SYSTEM 2/2
Call
screening
Remote code
Recording
time
Number of
rings
Message alert
tone
Previous
NUMBER OF RINGS
5 Rings
6 Rings
Toll Saver
2 Rings
3 Rings
4 Rings
Note: If Smart call blocker is on, the rst ring of all calls will be muted.
# of rings
ECO
3
ECO