14
Getting started
Battery installation & charging
Install the battery as shown below. After installing the battery, you can make
and receive short calls, but replace the handset in the telephone base or
additional charger when not in use. For optimal performance, charge the
handset battery for at least 16 hours before use. When fully charged, the
handset battery provides approximately five hours of talk time and three days
of standby time.
Press the tab and
slide the battery
compartment
cover downwards.
Insert the supplied battery as
indicated. Insert the top edge
(contacts and tab) in first,
then push downwards on the
lower portion of the battery.
Align the cover flat
against the battery
compartment, then
slide it upwards
until it clicks into
place.
IMPORTANT INFORMATION
1. Use only the battery supplied with this product. To order a replacement
or spare battery (AT&T model 103, part number 89-0429-00-00) or
equivalent, visit our website at www.telephones.att.com, or call
1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. See the Troubleshooting section on page 92 for charging issues.
Charge the handset face up in telephone
base, or place the handset in the
additional charger (EP5632-2 only). The
CHARGE light will be on when charging.
To Next Page
Loading...
Need help?
General
