54
System setup
Msg Alert Tone
By default, Msg Alert Tone is off. When the
message alert tone and the answering system is
on, telephone base will beep every 10 seconds
when you have a new message on the answering
system.
To change this setting:
1. Press the MENU softkey on the telephone base
to enter the main menu.
2. Press the UP and DOWN NavKeys to highlight
Answering System, then press the SELECT
softkey to enter the Answering System menu.
3. Press the UP and DOWN NavKeys
to highlight
Msg Alert Tone, then press the SELECT
softkey.
4. Press the UP and DOWN NavKeys to highlight
On or Off, then press the SET softkey to save
the setting.
NOTE: If the message alert tone is on, but the answering
system is off, the telephone base will not beep when there
are new messages.
Answering System
Call Screening
Remote Code
Msg Alert Tone
Select
Msg Alert Tone
On
P
Off
Set
To Next Page
Loading...
Need help?
General
