AT&T Four-Line Intercom Speakerphone 974 - Page 68

Store a Temporary Tone Signal in a
Directory Number
If you have dial pulse (rotary) service, you can store tone
signals in a directory number. When you reach the place in
the dialing sequence where you wish tone dialing to begin,
press - until the screen displays:
Press E. All digits entered after this will send tone
signals.
Store a Flash in a Directory Number
You can store the switchhook flash needed to access some
custom-calling services in a directory number. When you
reach the place in the dialing sequence where you wish to
enter a flash, press - until the screen displays:
Press E to store the flash, then continue entering the
number. Each flash counts as one digit.
JIMTERXNAMELLXX
555_
XXXXXXXXXXXXXXx
FLASHXNUMBERXXXx
JIMTERXNAMELLXX
555_
XXXXXXXXXXXXXXx
TONEXXNUMBERXXXx
63
DIRECTORY OPERATION
DIRECTORY OPERATION
l
l
l
i
ii
ii
974_CIB_1ATT_033104 3/31/2004 5:28 PM Page 63