AT&T Four-Line Intercom Speakerphone 974 - Dial a Number from the Directory; Remove a Name and Number from the Directory; Remove All Entries from the Directory

66
DIRECTORY OPERATION
DIRECTORY OPERATION
n
nn
nn
i
ii
iii
ii
iii
ii
iii
ii
ii
i
ii
ii
Dial a Number from the Directory
1 Find the entry for the number you wish to
call by following the directions under “Review
Directory Entries” on page 64.
2 Press E. The screen display includes DIAL.
3 Press E. The phone will automatically select
an idle line and dial the call
— OR —
Press the LINE button for the line you wish to
use, then press E to place the call.
The call will be dialed in the mode (speakerphone
or headset) you programmed (see“Set Automatic
Mode” on page 33).
Remove a Name and Number from
the Directory
1 Find the entry for the number you wish to
call by following the directions under “Review
Directory Entries” on page 64.
2 When the entry you wish to delete is displayed,
press r. The screen display includes
REMOVED!. The screen automatically returns to
the first directory entry.
Remove All Entries from the
Directory
1 Press D to begin working with the directory.
2 Press r. The screen display includes
REMOVE:ALL?.
3 Press r again within three seconds to
confirm the command and remove all directory
entries. The screen briefly displays:
The screen automatically returns to:
DIRECTORYXFULLXX
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXx
ADDWENTRYESXXXXx
(empty)XFULLXX
XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXx
AllxRemoving!
i
ii
ii
i
ii
ii
974_CIB_1ATT_033104 3/31/2004 5:28 PM Page 66