AT&T GL2113-31 - Number of Rings

109
Answering system
Answering system settings
Number of rings
You can set the answering system to answer an incoming call aer two, three,
four, ve, or six rings. You can also select toll saver, which is explained below. By
default, the answering system answers an incoming call aer four rings.
To set the number of rings:
1. Press MENU/SELECT in idle mode.
2. Press CID or to highlight Answering sys, then press
MENU/SELECT.
3. Press CID or to highlight Ans sys setup, then press
MENU/SELECT.
4. Press CID or to highlight # of rings, then press
MENU/SELECT.
5. Press CID or to choose from 6, 5, 4, 3, 2 or Toll saver.
f Toll saver - the answering system answers a call aer
two rings when you have new messages, or aer four rings when there is
no new message. This feature allows you to check for new messages and
avoid paying long distance charges when calling from out of your local
area.
6. Press MENU/SELECT to save.
Note: If Smart call blocker is on, the rst ring of all calls will be muted.
# of rings
ECO
3
ECO