AT&T GL2113-31 - Call Block Settings; Set Smart Call Blocker On;Off; Set Profile

80
Smart call blocker
Call block settings
Set Smart call blocker on/o
The Smart call blocker feature is set to on by default.
1. Press MENU/SELECT to enter the main menu when the
handset is not in use.
2. Press CID or to scroll to Smart call blk, then press
MENU/SELECT.
3. Press MENU/SELECT again to select SCB On/Off.
4. Press CID or to highlight On or Off, then press
MENU/SELECT to save the setting. You hear a
confirmation tone.
Note: If you set SCB On/O to O, all settings under Set prole (see below) will be invalid.
Set prole
There are ve prole setting options, which allows you to quickly set up Smart
call blocker.
1. Press MENU/SELECT to enter the main menu when the handset is not in use.
2. Press CID or to scroll to Smart call blk, then press MENU/SELECT.
3. Press CID or to scroll to Set profile, then press
MENU/SELECT.
4. Press CID or to select one of the following options,
then press MENU/SELECT.
f Screen unknown - screen any home calls without
numbers or with numbers not saved in the phonebook,
allow list, or star name list.
− This prole setting sets the telephone to screen all unknown home
calls and asks the callers to say their names before putting the calls
through to you. See Screen unknown home calls on page 99.
f Screen robot - screen robocalls.
− This prole setting sets the telephone to screen all unknown home calls and asks the
callers to press the pound key (#) before putting the calls through to you. See Screen
robocalls on page 102.
f Allow unknown (default setting) - allow all unknown home calls to ring,
except calls with numbers saved in the block list.
− This prole setting sets the telephone to allow all unknown home calls to get through and
ring. Calls with numbers saved in the block list will be rejected.
Smart call blk
ECO
SCB On/Off
ECO
Set profile
ECO
Screen unknown
ECO