66
Answering system
Setting your system to automatically answer calls
An example of a 4-line answering system setup
If you have four phone lines and many extensions, you can set up to the
auto attendant to answer up to three simultaneous calls. You can set up the
fourth line to ring as a private direct line to a single extension by excluding
all others in the Ring group (page 18).
Line 1 : Auto attendant (2 rings)
Line 2: Auto attendant (2 rings)
Line 3: Auto attendant (2 rings)
Line 4: General mailbox (4 rings, all but one extension excluded)
Select the answer mode
When the telephone is idle, press ANSWER ON for the
desired line.
Press or to scroll to the desired answer mode
(Ans->Gen MB only, Ans->Auto att, or No answer).
Press MENU/ENTER to select the mode. To exit without
making changes, press EXIT.
Answering system capacity
You can record up to five new announcements to have different
announcements for each line. Each announcement can be up to two minutes.
Auto attendant and general mailbox announcements both require system
memory to record, so we suggest recording brief announcements in order to
leave more space for messages.
The maximum recording time of all handsets and base is 180 minutes.
The actual recording time depends on individual message characteristics.
Individual messages can be up to three minutes. Messages remain available
for review until you delete them.
If the system memory is full, the screen displays Message full, and you
cannot record new messages until old ones have been deleted. Check
remaining system space frequently to keep maintain availability of space for
incoming messages.
NOTE: You cannot record an announcement when the telephone system is out of space.
You will hear a two-beep alert tone and voice prompt “Memory is full.” Please refer to
Remaining space on page 32.
1.
2.
Ans->Gen MB only
Ans->Auto att
No answer
Setup
>
On
To Next Page
Loading...
