AT&T TL 7610 User Manual

15
Getting started
Headset base installation
Option 2: Headset base stand-alone installation
In order to make calls using thisusing this installation option, you need a, you need a
telephone plugged into the same telephone line. Make sure the
headset base mode is set to NO LIFTER MODE.
Plug one end of the
telephone line cord
into the TEL WALL
JACK (red dot) at
the back of the
headset base.
•
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
The DSL filter must be
plugged into the telephone
wall jack.
Telephone
line cord
Plug the other end of
the telephone line cord
into a telephone jack.
•
Plug the headset
base power adapter
into an electrical
outlet not controlled
by a wall switch.
•
Plug the small end of
the headset base power
adapter into the POWER
jack (green dot) at the
back of the headset base.
•

AT&T TL 7610 Specifications

General

Brand	AT&T
Model	TL 7610
Category	IP Phone
Language	English