AT&T TL 7610 User Manual

19
Getting started
Adding and registering a headset to the
headset base
To register a headset to the headset base
Make sure the battery is properly installed in the
headset (see page 8). The ON/OFF light flashes
twice every five seconds to indicate the headset is
not registered.
Place the headset in the headset base and
allow it to charge for at least five minutes
before the registration.
Remove the headset from the headset base.
Press and hold the PAIR button until the
MUTE light on the headset base turns on
(about four seconds) and release the button.
Return the headset to the headset base
for registration.
It may take about 30 seconds to complete the
registration. The MUTE light on the headset
base turns off. The headset ON/OFF light turns
blue on the first headset registered and orange
on the second headset registered.
To verify the registration was successful, press
the headset ON/OFF button and check for a
dial tone.
If the registration fails, the ON/OFF light
on the headset flashes twice every five seconds. To reset the
headset, remove the headset from the headset base and try the
registration process again.
1.
2.
3.
4.
5.

AT&T TL 7610 Specifications

General

Brand	AT&T
Model	TL 7610
Category	IP Phone
Language	English