31
Operation
Headset operation
Ending a call on the headset
When the headset base is plugged into the telephone wall jack
(installation option 1 or 2):
Press ON/OFF on the headset or place the headset in the
headset base.
When the headset base is connected to a multiple line or
digital business corded telephone (installation option 3):
Press ON/OFF on the headset or place the headset in the
headset base.
Hang up the corded handset by placing it in the telephone base.
Auto off
A call ends automatically when you put the headset in the
headset base.
Temporary ring tone silencing
Press MUTE/FLASH to temporarily silence the ring tone in
the headset earpiece. This silences the ring tone without
disconnecting the call. The next incoming call rings at the
preset volume.
NOTE: If you have more than one headset registered to the headset base, both
headsets receive the ring tone when there is an incoming call. Pressing MUTE/FLASH
on one headset only silences the ring tone of that particular headset.
•
1.
2.
To Next Page
Loading...
