99
Answering system
Remote access
You can access the answering system remotely by dialing your
home telephone number from any touch-tone telephone.
To remotely access the answering system
Dial your telephone number from any touch-tone telephone.
When the system plays your announcement, enter the 2-digit remote access
code (19 is the preset code, see page 90 to change it).
You can also enter the remote commands (see Remote commands below).
Hang up or press 8 to end the call and save all undeleted messages.
Remote commands
1.
2.
3.
4.
1
Press to listen to all messages.
2
Press to listen to new messages only.
3
Press to delete the current message (during playback).
33
Press twice to delete all old messages.
4
Press to repeat the current message (during playback).
44
Press twice to listen to the previous message.
5
Press to stop.
*5
Press to listen to a list of remote commands.
6
Press to skip to the next message (during playback).
*7
Press to record a new announcement.
8
Press to hang up the call.
0
Press to turn the answering system on or off.
To Next Page
Loading...
