AT&T TL96547 - PTT Call to a Single Device

79
Multiple handset use
Push-to-talk (PTT)
PTT call to a single device
Using a handset:
1. There are a few ways to begin a PTT call to a single device. When the handset
is not in use:
f If you have one handset, press and hold PUSH TO TALK in idle mode.
f If you have more than one handset, press PUSH TO TALK in idle mode:
 Use the dialing keys to enter the destination device number (0 for
telephone base, 1-9 for handsets 1-9, TONE and 0 for handset 10,
TONE and 1 for handset 11 or TONE and 2 for handset 12).
-OR-
 Press CID or DIR to scroll to the destination device, then press
SELECT or PUSH TO TALK.
The handset displays Connecting to HANDSET X... (HANDSET represents
the handset name, X represents the destination handset number) or
Connecting to BASE 0... (BASE represents the base name) for a few
seconds. When the connection is made, both the initiating handset and the
destination device display Press and hold [PTT] to talk and beep once.
2. Press and hold PUSH TO TALK. A chirp indicates your microphone is on.
Speak towards the handset. Your voice is broadcast to the destination
device. While you are speaking, the handset displays PTT To HANDSET X
(X represents the destination handset number) or PTT To BASE 0.
3. Release PUSH TO TALKaerspeaking.Bothdevicesbeeponceagainand
the screens show Press and hold [PTT] to talk, then you can press and hold
PUSH TO TALK to continue speaking or the destination handsets can respond
(see Answer a PTT call on page 83).
4. To end the PTT call, press OFF/CANCEL or END, or place the handset in the
telephone base or charger. The handset shows Push to talk Ended for a few
seconds.
Note: Aer PUSH TO TALK is released, the PTT call remains open for a short time. If no one presses
PUSH TO TALK within 10 seconds, the PTT call ends automatically.