EasyManua.ls Logo

ATC K-Series - Safety

ATC K-Series
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
KT1 series chillers Installation and Operation manual
Issue 3.2 3
Safety
For your safety we draw your attention to the following Warning and Caution statements
throughout the manual.
The safe operation of a KT series chiller always remains the responsibility of the operator.
Caution: Failure to comply with a Caution will invalidate product warranty and absolve
ATC from any liability, howsoever caused, and could result in permanent dam-
age to equipment.
Warning: Use of this equipment in any manner not specified by the manufacturer may
result in the protection provided by the equipment being impaired.
Warning: Failure to comply with a ‘Warning’ may result in personal injury or death. ATC
does not accept any liability for injury caused through use of this equipment.
Warning: No user serviceable parts.
Warning: Very hot surfaces, in excess of 100°C
Warning: Very cold surfaces and gases, lower than -40°C. Severe frostbite hazard.
Warning: Opening the refrigeration system may expose the operative to toxic and cor-
rosive compounds (HFC’s). Take protective measures including suitable eye
protection.
Warning: Gases may exceed 300 psi (20 bar) during operation.
Warning: All refrigerants do not support combustion and are asphyxiating gases.
Warning: After switching off, the fan blades continue to rotate. Do not attempt service
whilst the blades are rotating.
Warning: All chillers contain water and electricity in close proximity. Always ensure the
unit is isolated before service. The KT1 has an on-off switch and four protec-
tive fuses. Never bypass these components.
Caution: Filling/topping up of the tank should only be undertaken with the unit
switched off, to prevent back-flooding of the fluid.