15
3. Setting the time: SET HOUR / DAY
This menu is used to initially set the time and day, and
also to change the time if required, for example during
daylight saving.
Use the and keys to select either the day of the
week, or (if the day is correct) the time to be modified.
Touch OK to enter the desired section to change.
Select the day by using the and keys, you can
choose from Monday to Sunday and confirm the correct day by touching OK.
When setting the time, the setting starts with the hour, select from 00 to 23 by using the and
keys. Once the hour is correct touch the OK key; the radiator will change to set the minutes,
selecting from 00 to 59 using the and keys and confirm by touching OK.
To go back to the CONFIG screen,
touch the MODE key at any time.
Daylight saving time will need to be
manually changed.
When the button cell battery life ends
(see pages 10 and 11), after a power
failure or disconnection from the mains of more than one minute the radiator will request the
user to set the hour/day, as the system clock is reset to Monday 00:00.
A battery icon will flash until the hour/day is set. After 30 seconds the
heater will choose Monday and 00:00 as the day and time and will return
to the last used mode of operation.
The heater will request the time to be set each time there is a power
disconnection of more than one minute or until the button cell is
replaced.
4. Open Window
This menu enables/disables the Open Window function (see page 17 of this manual). Select ON
/ OFF with the and keys and confirm with the OK key; the heater will return to the CONFIG
screen after a selection is made.
5. Adaptive start control
This menu enables/disables the Adaptive start control (see page 18 of this manual). Select ON /
OFF with the and keys and confirm with the OK key; the heater will return to the CONFIG
screen after a selection is made.
To Next Page
Loading...
Need help?
General
