SMART TDS & BOTTOM BLOWDOWN CONTROLLER
5.2.8 Conductivity Blowdown System Auto / Off
In this mode can be setted as "System On" that gives an automatic blowdown or
"System Off" that the timer will give no blowdown.
This mode gives an automatic blowdown, and is the usual
In this mode, the blowdown controller will give no
Automatic blowdown is prevented on this boiler.
5.2.8 Conductivity Blowdown Valve Maneul Open
In this mode can be Conductivity Blowdown Valve open manually until any button is
To hold the valve open, press button for 5 second on
this function. In this case the boiler will be drain.
The valve will automatically shut down when any key is
5.2.3 Bottom Blowdown Interval
This function is used to adjust the time between two bottom blowdowns.
Lower row numbers show the bottom blowdown interval time that adjusted previously.
Time format is Hour : Minute.
Interval between two bottom blowdowns can be set to
To Next Page
Loading...
