ATECH BC 970 - Software Version

SMART TDS & BOTTOM BLOWDOWN CONTROLLER
5.2.16 Software Version
Allows the software version to be viewed.
6. COMMISSIONING
• Be sure that all phase and neutral ends are connected to the right terminals on Combi TDS Blowdown and Bottom
Blowdown Controller BC 970 before energyz.
• Be sure that all function values are adjusted correctly.
• Be sure that all wiring made correctly in compliance with "Automatic TDS Blowdown Valve BCV 900 Installation
and Operating Instructions" and "Automatic Bottom Blowdown Valve BCV 700 Installation"
• Be sure that all wiring made correctly in compliance with "Conductivity Probe CP 920, CP 930 or CP 950 Installation
and Operating Instructions"
7. MAINTENANCE
Please make sure to remove the main supply before detach the device.
Warning!
Otherwise this may cause damage to the product, personal injuries or even death.
The device is not subject to repair and / or maintenance other than by authorized
service personnel.
When any fault situation occurs or maintenance is necessary, please contact with “
“Atech Service Department”
It is recommended to perform the function tests regularly.
IM-BC970-18F Page 14
BC 970
www.atech-ltd.com