SMART TDS & BOTTOM BLOWDOWN CONTROLLER
5.2 . Commissioning - Function Configurations
5.2.1 Startup Screen
When device is powered, the screen likes the figure on the left.
Then conductivty prosses value, will be seen at the first row on the screen of the
controller. For Bottom Blowdown hours and minutes to next blowdown can be seen
at the second row on the screen of the controller.
5.2.2 Enter Commissioning
Hold down button for 5 seconds to enter commissioning mode.
To obstruct unauthorized interferences, BC 900 has password protection.
and buttons change each digit and button passes the next digit.
After change the last digit, button accepts the password and if it is true, it
automatically enters the main menu.
This function is used to set the conductivity value of blowdown.
Set Point is the TDS level at which the valve will open.
Set point should set in accordance with the
boiler manufacturers recommendations.
For example, 5.000 µS/cm value would be appirate
for fire tube / shell steam boilers.
To Next Page
Loading...
