ATEQ BH SENS DT41 - Change Buzzer on Settings; Change Auto off Settings

BH SENS DT41 – User Manual
UM-KJHU2-05-02 Page 31/41
AUTO: display sensor ID format in the way sensor is transmitting.
DECIMAL: force to display sensor ID in decimal (0 to 9).
HEXADECIMAL: force to display sensor ID in hexadecimal (0 to F).
NOTE: Some OE sensors manufacturers print sensor ID at housing in decimal format. In
this case, you can easily set your tool to display IDs in decimal format to verify the reading
done with the TPMS tool.
1.3. CHANGE BUZZER ON SETTINGS
When buzzer on is set to YES, a beep is triggered when the sensor ID is detected.
Scroll up and down to
select function or settings.
= continue
= previous
The selection turns red.
Scroll up and down to
select YES or NO.
= continue
= previous
1.4. CHANGE AUTO OFF SETTINGS
Scroll up and down to
select function or settings.