ATEQ D670 User Manual

13 / 93
FG_D6_CCLINK_EN_02 / 2020-06-17
SETUP OF THE OUTPUT MODE
The output mode is used to command the output to hold their value or to clear it after being set.
The output modes are:
— Clear output
— Hold output
The output mode configured in the ATEQ device must be the same as the one provided to the master.
5
th
Series:
From the MAIN MENU screen of your ATEQ device
go to
➢ CONFIGURATION
➢ FIELDBUS
➢ HOLD M.
6th
Series:
From the MAIN MENU screen of your ATEQ device
go to
➢ CONFIGURATION
➢ AUTOMATISM
➢ FIELDBUS
➢ MODE

ATEQ D670 Specifications

General

Brand	ATEQ
Model	D670
Category	Test Equipment
Language	English