ATEQ F520 - Starting a Measurement Cycle; Stopping a Cycle

Chapter 3 – Start-up and settings
UM-23100B-U User manual ATEQ F CLASS Page 34/90
6. STARTING A MEASUREMENT CYCLE
Press the START key to start
a measurement cycle.
RUN/P
r:
004
PRESS =0.500 bar
READY
The cycle phases are
displayed on the LCD
window :
WAIT,
FILL,
STAB,
TEST,
DUMP.
RUN/P
r:
004
PRESS =1.00 bar
STABILISATION
7. STOPPING A CYCLE
Press the RESET key to stop
the measurement. The display
“READY” indicates that the
instrument is ready to perform
a new measurement test.
RUN/P
r:
004
PRESS =0.500 bar
READY