ATH 7226 - Maintenance or Service Plan

® Copyright ATH-Heinl GmbH & Co. KG, 2019, All rights reserved / Misprints and technical changes reserved / As of: 2019-01
Manufacturer ATH-Heinl GmbH & CO.KG
- 25 -
4.4 Maintenance or Service Plan
Interval
Immediately
Weekly
Monthly
Every 3
months
Every 6
months
Check of ALL safety-relevant parts X
Cleaning X
Check or restore surface protection X
Check for leaks in the hydraulic system
X
Check or restore surface protection or corrosion protection
X
Check or restore damage to the paint and components X
Check or restore rust damage X
Check or treat cavities and non-painted areas X
Check for leaks in the pneumatic system X
Control the tightness of screws
X
Check, lubricate & adjust bearing slack X
Check wear parts X
Check fluids (level, wear, contamination, quality) X
Check and lubricate sliding surfaces X
Remove any dirt inside
X
Clean and check electrical components
X
Check motor and transmission for function and wear X
Check welds and construction X
Visual inspection (according to inspection plan) X