♦
Disassemble the bolt cage (N).
♦
Screw the cover onto the main bearing pin.
♦
Tighten the cover handtight using a rod or pipe.
♦
Disassemble the two Allen screws (L) and keep
them safe.
♦
Secure the cover by fitting the Allen screws (K).
♦
Tighten the Allen screws (K) with the tightening
torque required (see chapter Bolt
connections/Tightening torques).
♦
Fit the hexagon head screw (M), which prevented
the main bearing pin slipping in, in the middle of
the main bearing pin.
© 2015 Construction Tools GmbH | No. 3390 5141 01 | 2015-11-16
Original instructions
32
CC 1700 U, 1700 SINSTALLATION
To Next Page
Loading...
