Condition Fault Remedy
Low Load Alarm triggered:
Compressor running with too low oil
temperature over a longer period of
time
Solenoid valve malfunctioning Replace valve.
Extreme low usage of compressor Increase loading profile (longer
and/or more load cycles
required).
If not possible, consult Atlas
Copco.
Converter fault codes
If a problem is detected by the converter, a specific code will appear on the Elektronikon
TM
display. Below table lists the most important error codes. If another code appears, please contact
Atlas Copco.
Tap the Alarm button to enter the status of the alarm.
Typical display when compressor is stopped by shutdown
Tap the alarm to display the Main Motor Converter Alarm.
(1) Main Motor Converter Alarm
(1) Status
(2) Triggered Status Word
(3) Format
Instruction book
2920 7110 05 99
To Next Page
Loading...
