Typical Main screen (4 value lines), GA MED with frequency converter
Text on images
(1) Compressor Outlet
(2) Flow (compressors with frequency converter)
(3) Off, Load, Shutdown,... (text varies upon the compressors actual condition)
(4) Menu
(5) Running hours
• Section A shows information regarding the compressor operation (e.g. the outlet pressure or the
temperature at the compressor outlet). On compressors with a frequency converter, the load degree (flow)
is given in % of the maximum flow.
• Section B shows Status icons. Following icon types are shown in this field:
• Fixed icons
These icons are always shown in the main screen and cannot be selected by the cursor (e.g. Compressor
stopped or running, Compressor status (running, running unloaded or motor stopped).
• Optional icons
These icons are only shown if their corresponding function is activated (e.g. week timer, automatic
restart after voltage failure , etc.)
• Pop up icons
These icons pop up if an abnormal condition occurs (warnings, shutdowns, service,...)
To call up more information about the icons shown, select the icon concerned using the scroll keys and
press the enter key.
• Section C is called the Status bar
This bar shows the text that corresponds to the selected icon.
• Section D shows the Action buttons. These buttons are used:
• To call up or program settings
• To reset a motor overload, service message or emergency stop
• To have access to all data collected by the regulator
The function of the buttons depends on the displayed menu. The most common functions are:
Designation Function
Menu To go to the menu
Modify To modify programmable settings
Reset To reset a timer or message
Instruction book
2920 7104 10 27
To Next Page
Loading...
