Atlas Copco Power Focus 6000 LV

Installation EN Power Focus 6000 LV
16
© Atlas Copco Industrial Technique AB - 9839 1081 01
Pin Use
1 Do not use
2 Do not use
3 Do not use
4 Do not use
5 Do not use
6 Do not use
7 Do not use
8 Do not use
9 Do not use
10 Do not use
Last controller
EM Stop IO-cable connector: Molex Micro-Fit, 5-pin
Use the following pin configuration:
Pin Function
1 Do not use
2 Do not use
3 Do not use
4 Do not use
5 Do not use
6 Do not use
7 Do not use
8 Do not use
9 Connect a jumper between pin 9
and pin 10
10 See pin 9
Resetting emergency stop
Resetting an activated emergency stop is done by the software.