Atlas Copco Power Focus 6000 LV

Power Focus 6000 LV EN Service
© Atlas Copco Industrial Technique AB - 9839 1081 01
19
Warning! The power cable is the main disconnecting device and should be placed readily accessible to
the operator. Before you open a Power Focus unit make sure that the power cable is unplugged.
Warning! If the power supply cable needs to be replaced, only use an Atlas Copco original replacement
cord. Use of another cable may result in dangerous situations.
Repair Instructions
Wiring
If it is necessary to change the plug on the mains cable, use the following wiring guide:
Color Input
Brown or black Live
Blue Neutral
Green and yellow Protective ground
Warning! The power cable is the main disconnecting device and should be placed readily accessible to
the operator. Before you open a Power Focus unit make sure that the power cable is unplugged.
Warning! If the power supply cable needs to be replaced, only use an Atlas Copco original replacement
cord. Use of another cable may result in dangerous situations.