Atlas Copco Power Focus 6000 LV

Power Focus 6000 LV EN Product Information
© Atlas Copco Industrial Technique AB - 9839 1081 01
7
Tool Mains voltage [V] Fuse [A]
ETD SL
ETP SL
ETV SL
ETF SL
115 10-16
230 10-16
If you are running the Power Focus 6000 LV as a stand-alone unit and trigger the tools manually (random)
it is normally possible to connect up to three Power Focus 6000 LV units to one power drop. If you are
synchronising the spindles you will need one drop for each Power Focus 6000 LV unit. The fusing in the
power drop shall be of time delay type.
Network Connections
Factory LAN - 100/100 Mb/s
Service LAN - 100/100 Mb/s
Network Connections
Factory LAN - 100/100 Mb/s
Service LAN - 100/100 Mb/s
Power consumption
Power consumption depends on the speed and torque of the tool. High speed and torque increase power
consumption.
The Power Focus 6000 LV has a maximum power consumption of 1300W. In order to calculate the power
consumption at particular torques and speeds, use the following formula:
P Power Md Torque
n speed
The power consumption in idle mode has been measured with no controller or tool accessories con-
nected.
Technical Product Data
Technical Product Data can be found on either ServAid, or the Atlas Copco website.
Please visit: https://servaid.atlascopco.com or www.atlascopco.com.
Service Overview
Service recommendations
Preventive maintenance is recommended at regular intervals. See the detailed information on preventive
maintenance. If the product is not working properly, take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow these general guidelines:
■ Replace any defective or worn parts