Atlas Copco Power Focus 6000 LV

Product Information EN Power Focus 6000 LV
6
© Atlas Copco Industrial Technique AB - 9839 1081 01
Tool Mains voltage [V] Fuse [A]
ETD SL
ETP SL
ETV SL
ETF SL
115 10-16
230 10-16
If you are running the Power Focus 6000 LV as a stand-alone unit and trigger the tools manually (random)
it is normally possible to connect up to three Power Focus 6000 LV units to one power drop. If you are
synchronising the spindles you will need one drop for each Power Focus 6000 LV unit. The fusing in the
power drop shall be of time delay type.
Power
The Power Focus 6000 LV operates on a single-phase 100-240 VAC, 50-60 Hz.
The Power Focus 6000 LV has a wide input with PFC.
Total current drawn from Emergency Stop and 24V out concurrently may not exceed 2A.
Technical data
Weight 10.8 kg
Length 292 mm
Width 146 mm
Height 325 mm
Power rating 1300 W
Rated voltage 100-240 V
Power
The Power Focus 6000 LV operates on a single-phase 100-240 VAC, 50-60 Hz.
The Power Focus 6000 LV has a wide input with PFC.
Total current drawn from Emergency Stop and 24V out concurrently may not exceed 2A.
Power consumption
Power consumption depends on the speed and torque of the tool. High speed and torque increase power
consumption.
The Power Focus 6000 LV has a maximum power consumption of 1300W. In order to calculate the power
consumption at particular torques and speeds, use the following formula:
P Power Md Torque
n speed
The power consumption in idle mode has been measured with no controller or tool accessories con-
nected.
Mains fuse
Recommended mains fuses (power outlet):