- 37 -
Maintenance schedule (km)
(continuation of page 36)
Daily 50 km
after initial
start-up
Every
500 km
Every
2000 km
Ye ar ly
Check coupling head x x x
Check height of adjusting facility x x
Check drawbar handbrake lever spring actuator, reversing lever, linkage
and all movable parts for ease of movement
xxxxx
Check tyre pressure xxxx
Check torque of wheel nuts x x x
Grease coupling head, drawbar bearings at the housing of the overrun
brake
xxx
Check brake system (if installed) and adjust if necessary x x x
Oil or grease brake lever and moving parts such as bolts and joints x x x
Check/Adjust lateral play of wheel bearing (conventional bearing) x x x
Check tyres for uneven wear xx
Grease sliding points on height adjusting parts xx
Check safety cable for damage xx
Check Bowden cable on height adjustable connection device for damage x x
Lubricate torsion bar axle trailing arm xx
Check hub cap for firm seating xx
Check brake lining wear x
Change wheel hub bearing grease x
To Next Page
Loading...
Need help?
General
