- 55 -
SPILLAGE-FREE FRAME
The compressor is fitted with a leak-proof
undercarriage in order to protect the environment.
Any leaking fluid is collected in case of malfunctions.
This fluid can be removed via a drain (1), normally
secured by caps.
Tighten the cap firmly and check for leakages.
Please observe the locally applicable environmental
regulations when removing the leaked liquid.
STORAGE
Run the compressor regularly, e.g. twice a week, until
warm.
Load and unload the compressor a few times to
operate the unloading and regulating components.
Close the air outlet valves after stopping.
If the compressor is going to be stored
without running regularly, protective
measures must be taken.
Contact Atlas Copco for correct
measures.
To Next Page
Loading...