- 57 -
Road light system
The right hand
traffic road light system includes rear
lights, stop lights, direction indicators, license plate
light, fog light and rear reflector and a 7-pin connector
to connect the lights to the towing vehicle. The entire
installation is EU type approved.
Wheel chocks are included when ordering the road
light system.
There is a 13 to 7 pin converter available as an option.
Aftercooler
The aftercooler option also includes a bypass valve
when operating at ambient temperatures below 10° C
(50° F). The bypass valve must be open to prevent the
system from freezing. Frost can damage the
aftercooler.
Lubricator
A tool lubricator is a reservoir that can keep 2.4 l of
lubricant. The lubricant is picked up by the outgoing
air and delivered to the pneumatic tool on the other
end of the air hose.
The amount of lubrication can be regulated by
Customer with a screw positioned right above the
lubrication reservoir, depending on the need of the
tool connected to the compressor.
Hose reel
The hose which is 16 m long
, winded on a reel. Do not
run over the hose while it is under pressure. Hose reel
must be winded up and hose end must be put in the
holder before transporting the unit.
Inlet shutdown valve
The actuation force to close the valve is depend on the
engine intake air flow passing through the valve. As
the air flow increases, this actuation force also
increases.
The force is resisted by an internal valve spring. Once
the actuation force exceeds the resisting force of the
valve spring, the valve rapidly moves to the closed
position. The valve remains close until the engine is
fully stopped. The valve then resets to the open
position after a delay of some seconds.
To Next Page
Loading...