13
6. There are four fixed holes in the machine, can fix the machine on ground by
3
/
4 X
4
3
/
4
anchor bolts. See Fig.23
. MAINTENANCE SCHEDULE
Monthly:
1. Maintance all the running friction parts with grease˗Fig.24
2.
Check all the joint,bolt or pin to make sure good connection.
3.
Visual check if all the hydraulic holes are weared and leaking.
Every six months:
1. Visual check the posibility wared, interference and damaged of all the running parts.
2. Check and fasten if the fastener parts are loosened.
Fig.23
To Next Page
Loading...
Need help?
General
