Atlas OH-10X - User Manual

Questions and Answers

M
Mrs. Lisa ChaneyAug 6, 2025
What to do if the motor runs but the Atlas OH-10X Lifting Systems lift is not raised?
- Y
  yjacksonAug 6, 2025
  If the motor runs but the Atlas Lifting System lift does not raise, there are several potential causes. The motor may be running in reverse rotation, which can be fixed by reversing two power wires. Alternatively, the gear pump may be out of operation, the release valve may be damaged, or the relief or check valve may be damaged; any of these would require repair or replacement. Finally, check the oil level and fill the tank if it is low.
A
ashley48Aug 11, 2025
Why is my Atlas OH-10X Lifting Systems lift raising slowly?
- J
  jose96Aug 11, 2025
  If your Atlas Lifting System lift raises slowly, it could be due to several reasons. The oil line might be jammed, requiring cleaning. The motor could be running on low voltage, so check the electrical system. Air mixed with the oil can also cause this issue; in that case, fill the tank. Additionally, a leaking gear pump would need replacement, or the lift might be overloaded, so check the load.
V
Vanessa CrawfordAug 17, 2025
What to do if my Atlas OH-10X lift cannot lower?
- D
  dylanmooreAug 17, 2025
  If your Atlas Lifting System lift cannot lower, first, ensure that the safety devices are not locking the lift; if they are, release the safeties. If that's not the issue, the release valve may be damaged and require repair or replacement. A broken safety cable would also prevent lowering and needs replacement. Finally, a jammed oil system can cause this, so clean the oil system.
S
shanebennettAug 25, 2025
Why does my Atlas Lifting Systems lift not stay up?
- E
  Elizabeth NortonAug 25, 2025
  If your Atlas Lifting System lift does not stay up, it could be due to a few potential issues. The release valve might be out of work, requiring repair or replacement. Alternatively, there could be leakage in the relief valve or check valve, which would also need repair or replacement. Lastly, check for leaks in the cylinder or fittings; if found, these components should be repaired or replaced.
K
keithjimenezAug 30, 2025
How to troubleshoot a motor that does not run on Atlas OH-10X?
- B
  Benjamin FoxAug 30, 2025
  If the motor of your Atlas Lifting System does not run, it could be due to several reasons. The button might not be working, requiring replacement. The wiring connections might be in poor condition, needing repair. The motor itself could be burned out, necessitating repair or replacement. Also, a damaged height limit switch or a burned-out AC contactor could be the cause, requiring their replacement.