Atlas PV-10PX - User Manual

Questions and Answers

D
Daniel LeonardAug 3, 2025
Why is my Atlas PV-10PX Lifting Systems lift raising so slowly?
- M
  Miranda BarajasAug 3, 2025
  If the Atlas Lifting System lift raises slowly, there might be several reasons: * The oil line could be jammed, in which case you should clean it. * The motor might be running on low voltage, so it's recommended to check the electrical system. * The oil could be mixed with air, requiring you to fill the tank. * The gear pump might be leaking, necessitating a replacement pump. * The lift might be overloaded, so you should check the load.
M
Madison AbbottAug 9, 2025
What to do if my Atlas PV-10PX Lifting Systems lift cannot lower?
- E
  Ethan DuranAug 9, 2025
  If your Atlas Lifting System lift cannot lower, consider these possible causes: * The safety devices may be locking, so release the safeties. * The release valve might be damaged, requiring repair or replacement. * The safety cable could be broken, so replace it. * The oil system might be jammed, so clean the oil system.
C
Colleen HollandAug 15, 2025
What to do if Atlas PV-10PX lift does not stay up?
- T
  Tiffany ClarkAug 15, 2025
  If your Atlas Lifting System lift does not stay up, it could be due to: * A release valve that is out of work, requiring repair or replacement. * Leakage in the relief valve or check valve, so repair or replace them. * Leaks in the cylinder or fittings, and you should repair or replace them.
K
kcarterAug 21, 2025
What to do if the motor of my Atlas PV-10PX Lifting Systems does not run?
- J
  jessica88Aug 21, 2025
  If the motor of your Atlas Lifting System does not run, the potential causes and solutions are as follows: 1. The start button may not be working, in which case you should replace the start button. 2. The wiring connections might be in poor condition, requiring you to repair all wiring connections. 3. The motor could be burned out, and you should repair or replace it. 4. The AC contactor might be damaged, so replace or repair it.
B
Brenda ZamoraAug 27, 2025
Why does the motor run but the lift is not raised in my Atlas PV-10PX Lifting Systems?
- J
  Justin WilsonAug 28, 2025
  If the motor in your Atlas Lifting System runs but the lift does not raise, consider the following: * The motor might be running in reverse rotation, in which case you should reverse two power wires. * The gear pump could be out of operation, requiring repair or replacement. * The release valve might be damaged, so repair or replace it. * The relief valve or check valve could be damaged, necessitating repair or replacement. * The oil level might be low, so fill the tank.