Atlas BP12000X - User Manual

Questions and Answers

J
Joel RodriguezAug 11, 2025
Why does my Atlas BP12000X Lifting Systems lift raise so slowly?
- C
  Carol BarrettAug 11, 2025
  If your Atlas Lifting System raises slowly, several factors could be the cause. The oil line might be jammed, so cleaning it is recommended. It's also possible that the motor is running on low voltage, requiring a check of the electrical system. Air mixed with the oil can also cause this issue, so fill the tank. Alternatively, the gear pump might be leaking, suggesting a repair or replacement. Finally, check the load, as overload lifting can cause this problem.
K
Kristine HoweAug 18, 2025
What to do if Atlas Lifting Systems motor runs but the lift is not raised?
- T
  tammy79Aug 18, 2025
  If the motor runs but the lift of your Atlas Lifting System isn't raising, it could be due to a few reasons. The motor might be running in reverse rotation, in which case you should reverse two power wires. Alternatively, the gear pump might be out of operation, requiring repair or replacement. It's also possible that the release valve, relief valve, or check valve is damaged, and you should repair or replace them. Finally, a low oil level could be the issue, so fill the reservoir.
T
tina74Aug 25, 2025
Why Atlas BP12000X lift cannot lower?
- L
  Lance GuerreroAug 25, 2025
  If your Atlas Lifting System cannot lower, it might be due to a few reasons. The safety devices might be locking, so release the safeties. The release valve could be damaged, requiring repair or replacement. A broken safety cable could also be the cause, so you should replace it. Finally, the oil system might be jammed, so clean the oil system.
R
Robin EvansAug 29, 2025
What to do if the motor of my Atlas Lifting Systems does not run?
- L
  Leah WhiteAug 29, 2025
  If the motor of your Atlas Lifting System doesn't run, it could be due to several reasons. First, the button might not be working, in which case you should replace it. Second, the wiring connections could be in poor condition, so you should repair all wiring connections. Third, the motor might be burned out, requiring repair or replacement. Finally, the AC contactor might be damaged, and you should repair or replace it.
A
Ann StoutSep 4, 2025
How to fix Atlas BP12000X Lifting Systems that does not stay up?
- T
  Tina SmithSep 4, 2025
  If your Atlas Lifting System does not stay up, several issues could be responsible. The release valve might be out of work, so repair or replace it. There could be leakage in the relief valve or check valve, and you should repair or replace them. Additionally, cylinder or fittings leakage can cause this issue, and you should repair or replace them as well.