Test Run 24
BP12000X
Test Run
1. Adjust synchronizing cable
Use a wrench to hold the cable fi tting, and use
another wrench to tighten the cable nut. Make
sure the two cables have the same tension.
If the carriage does not synchronize
when lifting, please tighten the cable nut
of the lower side carriage. (See Fig. 30)
2. Adjust safety cable
Lift the carriage and lock at the same height. Strain the safety cable, release
a little, and then tighten the cable nuts. Make sure the safety locks can always
work properly.
3. Adjust the lower speed (Only for Atlas power unit)
You can adjust the lower speed of the lift if needing: Loosen the Fixing Nut of
the throttle valve, and then turn the throttle valve clockwise to decrease the
lower speed, or counterclockwise to increase the lower speed. Do not forget to
tighten the fi xing nut after the lower speed adjustment has been done.
Fig. 31
Cable
nut
Fig. 30
Counterclockwise to
increase the down speed
Clockwise to decrease
the down speed
Throttle
Valve
Fixing
Nut
To Next Page
Loading...
Need help?
General
