Operation Instructions 26
BP12000X
Operation Instructions
Please read the safety tips carefully before operating the lift
To lift vehicle
1. Keep work area free of clutter;
2. Position lift arms to the lowest position;
3. Open lift arms;
4. Position vehicle between columns;
5. Move arms to the vehicle’s lifting points;
Note: The four lift arms must at the same time contact the vehicle’s
lifting points where manufacturers recommended
6. Press the UP button until the lift pads contact underside of vehicle totally.
Recheck to make sure vehicle is secure;
7. Continue to raise the lift slowly to the desired working height, ensuring the
balance of vehicle;
8. Push lowering handle to lower lift onto the nearest safety. The vehicle is ready
to repair.
To lower vehicle
1. Keep work area free of clutter;
2. Press the button of UP to raise the vehicle slightly, and then release the
safety device, lower vehicle by pushing lowering handle.
3. Open the arms and position them to the shortest length;
4. Drive away the vehicle.
5. Turn off the power.