17
Water is too
hot.
The water ow rate
through the heater is too
slow.
Increase the ow rate at the water outlet.
Temperature setting is too
high
Switch to a lower temperature setting.
Water Temperature at
faucet is too hot.
Check for too little ow, or if the set point temperature is too high.
This could possibly indicate a possible internal part failure. Call us for
technical assistance.
Heater shuts
o during use.
Power outage or faulty
wiring.
Check the power supply. Check the circuit breakers.
If the problem persists, please call us for further technical assistance.
Water stops
owing.
Possible Blockage in water
pipes or hoses.
Make sure the main water line valve is fully open, and there are no
obstructions in the water supply line.
Water
temperature
varies from hot
to cold during
use.
Water pressure has
dropped below a minimum
level.
Increase the ow rate from the water supply source.
To Next Page
Loading...
Need help?
General
