How to fix speed control if it does not operate on my Atomik 18?
If the speed control on your Atomik Toy isn't working, first ensure that both the transmitter and receiver are switched on. Next, check that the batteries are fully charged. If the problem persists, the radio might not be installed correctly, so try reinstalling it.
What to do if the motor does not operate on my Atomik Toy?
If the motor of your Atomik Toy isn't working, start by charging the batteries. If that doesn't solve the issue, check the radio installation and reinstall it correctly if needed. Also, ensure the motor wire connections are secure. If none of these steps work, the motor may be damaged and require replacement or repair.
Why does the motor rotate, but the boat does not move on my Atomik 18?
If the motor of your Atomik Toy is rotating but the boat isn't moving, it's likely that the motor coupler set screw is loose. You should tighten the set screw.
What to do if propellers do not rotate freely when disconnected from the motors on my Atomik Toy?
If the propellers on your Atomik Toy don't rotate freely when disconnected from the motors, it's probably because the flex shaft and/or bearings are dirty. You should clean and regrease them.
Instructions on how to program the ESC using the transmitter.
Steps to enter the ESC programming mode via transmitter.
How to select ESC tuning categories using beep patterns.
Essential checks to perform before launching the boat.
To Next Page
General
