Important Warnings
Charging Instructions
Proper Connection & LED Indicators
LiPO Battery Safety Guidelines
Charging and discharging batteries has the potential for re, serious injury to persons and damage to
property. The user of this charger agrees to accept responsibility for all such risks. Atomik®, its aliates,
manufacturers, distributors, and retail partners cannot control the use, application, charging or installation
of this product and shall not be held responsible for any accident, injury to persons, or damage to property
resulting from the use of this product.
REFER TO THE LiPO SAFETY GUIDELINES IN THESE INSTRUCTIONS FOR MORE INFORMATION.
Always use a charger specically designed for LiPO batteries. ONLY charge 2 - 3 Cell LiPO Batteries with this
charger. Never use NiCD or NiMH type chargers to charge LiPO batteries. Failure to do so will damage the
batteries and may cause re and personal injury. Read all Safety Guidelines, Charging Instructions, New
Battery Break-In, and Battery Disposal Instructions before using batteries. Store battery packs out of the
reach of children and pets. Children under the age of 18 must be supervised by a responsible adult.
1) Plug the power cord into the LiPO Balance Charger and then into an open wall outlet.
2) All three cell indicator LEDs will illuminate green indicating power is applied and is ready to charge.
3) Plug the LiPO battery into the correct charging port on the charger. The cell indicator LEDs will change
from Green to Red indicating that the battery is charging.
4) When charging is complete, the LEDs will change from Red to Green. Charge times will vary depending on
the capacity of the battery and if there is already a partial charge on the battery. Time estimates are based
on a battery discharged to 3.0V per cell.
5) If the battery gets warm or hot during charging, immediately disconnect the battery, set it on a
non-ammable surface and allow it to cool down. During the cool down period, monitor the pack for any
signs of swelling or “ballooning” indicating a damaged battery. If the battery is damaged, follow the
disposal instructions found in the “LiPO Battery Safety Guideline” section in this manual.
1) Power Plug
2) Charging LEDs
3) Battery Balance Ports
1. Always use a charger specically designed for Lithium Polymer batteries. Never use NiCD or NiMH type
chargers to charge LiPO batteries. Doing so will damage the batteries and may cause re and personal injury.
2. Always charge batteries in a re proof container or in the open, away from ammable materials. Do not
charge batteries on wood, cloth, carpet, in your model, or on any other ammable material. Keep a chemical
re extinguisher nearby in case of re.
3. Never leave batteries unattended while charging. Always observe batteries when charging so that you
may react quickly to any problems that may occur.
To Next Page
Loading...
