10
Step 2 (B2): Installation of step jaws jaws (method 2)
5.Installation guide
Note:
1. When engraving a cued suace, take the average value of the diameter/circumference of the actual engraving
range of the measured object (the average value of the left, middle and right of the engraving range position)
2. When tilting and engraving, adjust the appropriate position of engraving by rotating the button
3. Non-circular bottom object engraving
Screw 3*6mm
H2.5 hexagonal
plate hand
Ladder jaws
To Next Page
Loading...
