may cause injury of the eye and skin burning.
1. Please wear on the eye protection when you are operating the laser engraver and R3 Rotary Roller
2. Refrain to expose the skin on Level 4 laser beam, especially close
3. It must be supervised by p arents or other adult person when the teenager operating our device
4. DO NOT touch the laser module when it is
2. Security of Fire Fighting
1. When Laser engraver operating with R3 Rotary Roller to cutting or engraving will burned up the basic material,
the high intensity laser will create extreme high temperature and massive
2. Some material will be burned during the cutting or engraving, and will cause some gas or
3. The lighting spot will create some flame when the laser beam shot at the material. The flame will move with the
laser and will not keep flaming when the laser moving. The operation must be supervised during cutting or
engraving. Please clear the sundry, scrap and flammable material after the cutting or engraving. Ensure there is
fire extinguisher at the workplace of the There is some smog, steam or particulate which could be poisonous (
plastic or some flammable material ) caused by material when the laser engraver operating, this smog, steam or
particulate may be harmful for your healthy.
3. Security of Material
1. DO NOT cutting or engraving any unknown
2. Recommended material: wood, bamboo, leather, plastic, fabric, paper, non-
3. transparent acrylic, glass Not recommended
4. Security of Operation
1. R3 Rotary Roller only operating on the horizontal flat, and make sure the Rotary Roller must be fixed firmly,
preclude fire when dropping or moving during the
2. It is forbidden to aim at people, animal or any flammable material, no matter under operation or
1.Disclaimer and warning
Atomstack product is not toy, not suitable for the people who is younger than 15.
Make sure DO NOT allow the children to tough any Atomstack product, be careful of children when you operate our
product accompany with children. Be careful when adjusting the product gear, Atomstack will not take the
responsibility due to the any harm cause by any incompatible our instruction behavior.
R3 Rotary Roller is a multi-function Rotary Roller, it will provide you engraving and cutting viewing experience under
the normal condition. Visit our website: http://www.atomstack3d.com/laserengrave to get the experience and user
manual. Shenzhen AtomStack Technologies Co., Ltd Atomstackwill own the right to update the Disclaimer and the
user manual.
Before using our product, please be sure to read this document carefully to understand your legal rights,
responsibilities and safety instructions; otherwise it may cause property damage, safety accidents and personal
safety hazards. Once you use this product, you should be deemed to have understood, accepted and accepted all
the terms and contents of this document. The user is responsible for his or her actions and all consequences arising
therefrom. The user agrees to use the product only for lawful purposes, and agrees to all the terms and contents of
this document and any related policies or guidelines that AtomStack may establish. You understand and agree,
unless you provide the original engraving or cutting files, the configuration parameters of the engraving software
used, operating system information, videos of the engraving or cutting process, and the operating steps before
problems or failures occur.
Atomstack will not take the responsibility to any lost which caused by the failure using of our product. AtomStack has
the final right to interpret the documents and comply with legal regulations. Atomstack reserves the right to update,
modify or terminate the terms without notice.
3. AtomStack R3 Rotary Roller brief introduction
AtomStack R3 collocates with laser engraver to process the engraving and cutting.
To Next Page
Loading...
Need help?
General
